blogs

A golf cart accelerator cable helps to control the speed of the vehicle. When it wears out or breaks, it can cause the golf cart

1. Remove the cover plate from the forward/reverse switch. Take care not to lose the small parts associated with the switch. 2. Unscrew the mounting

A throttle sensor is a critical component of any golf cart, as it helps the vehicle to maintain a consistent speed and power output. If

1. Remove the old starter motor from the golf cart. Disconnect the wiring harness from the starter motor and remove the starter motor from the

1. Park the golf cart on a level surface and set the parking brake. Make sure the engine is off and wait for it to

1. First, purchase a golf car seat warmer kit from a store or online. Make sure the kit is compatible with your specific golf car

1. Disconnect the battery from the golf cart. This will prevent any electrical shock from occurring when working with the wiring. 2. Remove the existing

1. Locate the seat belt on the side of the golf cart. 2. Pull the belt out and locate the two adjustment clips on either

1. Begin by removing the old belts. Start by unclasping the release buckle. Then, unthread the belt from the seat and the lap bar. 2.

1. Remove the wheel and tire: Before you can replace the disc brake rotor, you must first remove the wheel and tire. Use a jack

1. Park the golf cart on a flat surface and turn off the power. Pull the parking brake lever to ensure the cart won’t move

1. Check the fuel and air mixture. An improper fuel and air mixture can cause the engine to run poorly or not at all. Adjust

1. Raise the hood of the golf cart and locate the cables. The cables will be connected to the engine and the battery. 2. Disconnect

1. Park your cart and shut it off. 2. Disconnect the negative battery cable from the battery. 3. Remove the existing fender using a wrench

1. Park the golf cart on a flat, level surface and make sure the engine is cool. 2. Remove the carburetor cover and the air

1. Prepare the Golf Cart: make sure that the golf cart battery is fully charged before beginning. 2. Install the Lights: The installation process for

1. Disconnect the battery cables from the golf cart battery. This will ensure that no electricity is flowing through the solenoid valve when you are

1. Park your car on a flat surface and turn off the engine. Place wheel chocks behind the rear wheels to keep the car from

1. Disconnect the battery cables from the battery. 2. Remove the old starter motor. 3. Remove the old mounting bolts. 4. Install the new starter

1. Disconnect the negative battery cable from the golf cart battery. Make sure the golf cart is in a safe and well-ventilated area before beginning.

1. Park the golf cart in a level area and set the parking brake. 2. Take off the oil filter cover. This is usually located

1. Cleaning the Carburetor: This is one of the most important methods of golf cart carburetor adjustment or repair. First, disconnect the fuel line and

In your golf cart, the performance of the primary and the secondary clutches determines whether it is capable of handling it quickly going up hills.

Here are the top 3 signs that you need to get your brake master cylinder checked out. 1. YOUR BRAKE PEDAL FEELS SOFT OR MUSHY