blogs

Accessing the Bushings: Depending on the location of the bushings, you may need to remove certain components to access them. This could include removing wheels,

Elevate the Golf Cart: Lift the rear of the golf cart off the ground using a suitable jack and secure it with jack stands. Ensure

Access the Brake Assemblies: Locate the rear wheels and remove the hubcaps if present. Depending on your golf cart model, you might need to remove

Remove the old carburetor: Disconnect the battery to prevent any accidental electrical issues while working on the engine. Remove the air intake tube and air

Disconnect the battery: Before starting any electrical work, disconnect the golf cart’s battery to prevent any accidental short circuits or shocks. Remove the old solenoid:

Access the brake assembly: Depending on your golf cart model, the brake assembly may be located on the rear wheels or in a drum assembly.

Choose a suitable steering wheel: Select a steering wheel that is compatible with your golf cart’s make and model. Ensure that the steering wheel comes

1. Start by removing the bolts attaching the air filter housing and carburetor to the engine block. Remove the air filter housing, carburetor, and any

1. Check for Spark: Using a spark plug tester, remove the spark plug from the engine and attach the spark plug tester. Turn the key

Installation 1. Secure the axle in the axle housing. Use a piece of wood to keep the axle in place while you secure it with

1. Disconnect the battery cables from the battery terminals. 2. Remove the cover from the golf cart’s resistor box. 3. Install the resistors in the

1. Begin by cleaning the area that you will be applying the fender flares to. Make sure to remove any dirt or debris that may

1. Disconnect the negative cable of the battery. 2. Remove the mounting bolts that hold the old coil in place. 3. Disconnect the wiring harness

1. Park the golf cart on a level surface and turn off the power. 2. Disconnect the negative cable from the battery. 3. Remove the

A golf cart accelerator cable helps to control the speed of the vehicle. When it wears out or breaks, it can cause the golf cart

1. Remove the cover plate from the forward/reverse switch. Take care not to lose the small parts associated with the switch. 2. Unscrew the mounting

A throttle sensor is a critical component of any golf cart, as it helps the vehicle to maintain a consistent speed and power output. If

1. Remove the old starter motor from the golf cart. Disconnect the wiring harness from the starter motor and remove the starter motor from the

1. Park the golf cart on a level surface and set the parking brake. Make sure the engine is off and wait for it to

1. First, purchase a golf car seat warmer kit from a store or online. Make sure the kit is compatible with your specific golf car

1. Disconnect the battery from the golf cart. This will prevent any electrical shock from occurring when working with the wiring. 2. Remove the existing

1. Locate the seat belt on the side of the golf cart. 2. Pull the belt out and locate the two adjustment clips on either