- 1
Right and left tie rod ends have different part numbers and different threads. Have your Advance Auto Parts Team Member label each part right and left.
-
-
2
With the vehicle raised using a jack and secured with jack stands, remove the wheels.
-
-
-
3
Loosen the pinch bolts that hold the tie rod end to the steering assembly or adjusting sleeve. Turn the steering wheel if you need better access.
-
4
Pull out and discard the cotter pin, then remove and discard the castellated or castle nut from where the tie rod end itself connects to other steering components.
-
5
Use a two-jaw or tie rod end puller to remove the tie rod end from the steering knuckle. Start slowly in order to seat the tool properly for good leverage.
-
6
Mark the position of the tie rod end on steering assembly with chalk or electrical tape, then remove by unscrewing. The marks will help you replace the new rods in roughly the same position, which will keep your alignment close to original.
-
7
If your particular tie rod ends come with grease fittings, install them now. Also install the rubber boots on each tie-rod end. Do not reuse any parts.
-
-
-
8
Install the new tie rods by reversing the disassembly procedure. Torque all nuts to specification using the torque wrench, making sure to line up the castle nut and hole for cotter pin installation. Be sure to install new cotter pin.
-
9
Use a grease gun to put approved grease into the tie rods’ grease fittings. Fill until you start to see grease seep out. Wipe off all excess grease using the cleaning rags to prevent brake contamination.
-
Not all greases are created equal. Make sure you’re using the right formulation and weight of grease for the job at hand.
-
10
Chances are your vehicle will be pretty squirrelly until an alignment is performed. Get an alignment to ensure proper handling and increase tire life.
“Keyword”
“where are the tie rods located”
“what are outer tie rod ends”
“what are tie end rods”
“how do you check tie rod ends”
“what are the best tie rod ends”
