1. Check the gas tank to make sure there is enough fuel for operation. Inspect the tank with a flashlight if necessary. Avoid using old gasoline which has been stored, add fresh gasoline as needed.
2. Remove the oil dipstick and check that the oil level is at or just above the add or fill maker. Add oil, if necessary, following the manufacturer’s directions and use the recommended weight oil.
3. Inspect the battery of the golf cart. Make sure the cables are securely connected. Use an adjustable wrench to tighten cables. Also check the water level, and if low, fill with distilled water. Use a brush to remove any corrosion from the terminals.
4. Examine the wiring and switches. Check electrical wiring for cuts or abrasion and repair with electrical tape. Check all switches to insure good wiring connections. Secure any loose connections by crimping with pliers, wrapping with electrical tape or tightening with a screw driver.
5. Remove the air filter from the engine to access the carburetor. Use a screwdriver to remove the retaining screw. Spray cleaner into the carburetor as well as the throttle linkage, which is located just below the carburetor. Reassemble the air filter to the engine.

“Keyword”
“throttle potentiometer sensor”
“mobility scooter throttle potentiometer”
“throttle potentiometer circuit”
“how to test potentiometer on golf cart”
“can you test a potentiometer in circuit”
“speed potentiometer”